Everything You Need To Know When Considering Installing A Shower Within Your Home!
Everything You Need To Know When Considering Installing A Shower Within Your Home!
The first decision you need to make is where you are going to install the shower. Are you going to save space and use your bath as a shower or will you have a separate unit? If you do wish to use your bath, there are several bath products designed specifically for the purpose. See our section on combination baths.
If you would like to install a separate shower unit without the need for doubling it up with the bath, there are several design considerations to make regarding its location and construction.
A complete shower unit may be purchased which includes all the necessary components. The shower, shower tray and walls of the cubicle are all pre-made and require only assembly and installation. Obviously, this set up is also relatively expensive.
Alternatively, you could build in a cubicle making use of the walls of the room and/or additional stud walls constructed to suit. This method is more labour intensive but can represent a considerable cost saving. It also has the advantage that it may be built to suit your requirements more exactly.
Building a shower cubicle
There are many possibilities for shower construction depending on the space available, the budget for the project and the taste of the user. The shower may be built against one wall and stud walls constructed on one or two of the sides. The shower could make use of the corner walls of the room. There is also the option of building a shower as an integral part of a cupboard arrangement. The ‘open’ side or sides may then have a screen or curtain installed. Access to the shower may be from one side or the corner of two sides.
Consideration at the design stage should also be given to the plumbing. It always looks far neater and professional if all the pipework is hidden from view. This can be achieved either by routing the pipes through the rear wall of the shower if this is possible, or by building a false wall in front of all the pipework.
Drainage from the shower tray can be a little problematical as the need for a ‘fall’ in the waste pipe can be difficult to achieve. The fact that the base of the shower is at floor level means that the waste will need to drop below it. If the joists supporting the floor run in the same direction as the waste pipe, there may be room to fit the waste within the floor depth. However, you’ve probably just discovered that yours run the other way. The way round this is to raise the base of the shower to provide the necessary slope of 6mm per 300mm length of waste pipe. A quick calculation will show you that the additional height of the base will not present too much of a problem. (a 3m run of waste will require the base to be lifted by 60mm). Some of the better shower trays come with an adjustable base height or optional plinths. Read the rest of this entry »